Re: About the web polygraph to test squid performance

On Fri, 2007-06-01 at 10:51 +0800, Leon Xiang Li wrote:

> I had tried to setup the polymix-4 test as your suggestion.
>
> I run polysrv on 174.19.100.1
> I run polyclt on 174.19.100.2
> I run squid on 174.19.100.3
>
> all the three servers are RHEL4 Linux.
>
> squid works well.
>
> My polymix-4.pg is enclosed
>
>
> But the test stop with server timeout.
>
> The client and server log is enclosed.

It looks like your robots cannot connect to the proxy or cannot get any
packets back from the proxy. Did you follow the HOWTO below? Did you
test client<->proxy and proxy<->server IP connectivity with ping
(specifying the right alias address as the source and destination IPs;
see Section 4.2)?

  http://www.measurement-factory.com/docs/PolyMix-4/

You will need to adjust the HOWTO a little to make work on Linux, but
all the major steps of setting up the network and DNS must be done for
the test to work.

While it is possible to simplify the workload (e.g., remove domain
names) but it is usually easier to start with defaults. PolyMix is a
realistic and, hence, complex test; running it by hand, especially for
the first time, is not trivial.

HTH,

Alex.

> 003.43| Connection.cc:488: error: 1/1 (s110) Connection timed out
> 003.43| error: raw write after connect failed
> 003.43| connection between 10.101.0.246:37457 and 174.19.100.3:3128
> failed at 0 reads, 0 writes, and 1 xacts
Received on Fri Jun 01 2007 - 17:18:25 MDT