foreign host name with NAT L4 switch

From: Joseph Mack (mack.joseph@epa.gov)
Date: Thu May 10 2001 - 07:33:29 MDT

Next message: Alex Rousskov: "Re: foreign host name with NAT L4 switch"
Previous message: Alex Rousskov: "Polygraph 2.5.5 available"
In reply to: Alex Rousskov: "Polygraph 2.5.5 available"
Next in thread: Alex Rousskov: "Re: foreign host name with NAT L4 switch"
Reply: Alex Rousskov: "Re: foreign host name with NAT L4 switch"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

I've just started using polygraph.

I can connect client-host
(it looks like you call this robot-host) with simple.pg. If
I connect via an L4 switch using NAT, the servers initially
reply, but give out "foreign host name" errors and then stop
delivering packets. I assume because of NAT, the dest IP's
have changed.

Is there anything I can do about this?

Joe

PS: is there a search engine for the mailing list archives?
I didn't find anything for "foreign" in the subject lines.
If there was anything in the body of the messages I wouldn't
have seen it.

-- 
Joseph Mack PhD, Senior Systems Engineer, Lockheed Martin
contractor to the National Environmental Supercomputer Center, 
mailto:mack.joseph@epa.gov ph# 919-541-0007, RTP, NC, USA

Next message: Alex Rousskov: "Re: foreign host name with NAT L4 switch"
Previous message: Alex Rousskov: "Polygraph 2.5.5 available"
In reply to: Alex Rousskov: "Polygraph 2.5.5 available"
Next in thread: Alex Rousskov: "Re: foreign host name with NAT L4 switch"
Reply: Alex Rousskov: "Re: foreign host name with NAT L4 switch"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Tue Jul 10 2001 - 12:00:19 MDT